1990 International 1976/ Failing 1250
1990 International 1976/ Failing 1250
$135,000 135,000
Available quantity: 1
Description
1990 international 1976/1250 Failing Water Well Drilling Rig
DT466 engine
433,630 total miles
Engine was rebuilt on 5/11/2006 new pistons sleeves, bearings, seals, rebuilt head
10 speed manual transmission with low range deep reduction Power inverter wired in cab to run 110 V plug-in microwave and storage box in place of passenger seat.
1976/1250 Failing Drilling Rig serial number is 906264 Mayhew hydraulic sliding table 8 1/2 inch Little giant, 2 inch swivel on Kelly, Kelly replaced two years ago with Kelly savers
5 x 6 x 1/2" piston Mud pump.
Two-stage air compressor 100 CFM at 1000 RPM at 125 psi Sand line winch Mud pit with 4 inch suction hose and sleeve Includes 320' of rod in rod box 2 7/8 inch pipe 15 feet long by two and three eights 2/7/8"pin box thread.
Hoist plug and rod holder bushing
Electric winch to pull stabilizer into it’s Tray
2 inch water hook up on both sides of the rig Diaphragm mud pump, located on helper side.
Rig Belt driven hydraulic pump ran by toggle switch for desander pump.
Replaced mud pump clutch 7/31/2019
All new plumbing hoses for model lines a couple years ago.
Assortment of extra parts and Tooling
Rig is ready to go Drill.
Specifications
Manufacturer | International 1976/ Failing |
Model | 1250 |
Year | 1990 |
Condition | Used |